





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
LC to LC duplex (DPX), OM3 multimode 50/125µm fibre, 3 m
Article 91.LL.372.00300
The Molex LC/LC DPX OM3 patch lead, article 91.LL.372.00300, is a 3 metre duplex multimode fibre optic patch cable with LC connectors at both ends. It is designed for short fibre links in structured cabling, where equipment in one rack or room needs to connect to a patch panel, switch or media converter.
Fibre patch leads are a small but important part of a network. A good lead gives a clean, reliable optical path between two ports, and the right choice of fibre grade and connector type keeps the link compatible with the equipment at each end. This Molex lead is built for that role.
Multimode fibre has a larger core than singlemode fibre, which allows light to travel in multiple paths. OM3 is a laser-optimised grade that supports higher data rates over multimode links than older grades such as OM1 or OM2. It is well suited to building backbones, data rooms and short-reach links between equipment. Because the core is 50 micrometres, this lead should only be used with multimode equipment and ports, not singlemode ones.
LC connectors are compact, with a 1.25 mm ferrule, and use a push-pull latch. Their small size lets densely populated switches and patch panels hold more links in less space. Many modern transceivers, media converters and fibre cards use LC ports, which makes LC/LC leads a common choice for equipment-to-panel and equipment-to-equipment connections.
The DPX duplex design keeps two fibres together in one cable. This simplifies cable management, because one lead carries both the transmit and receive paths for a single link. Make sure the lead is connected with the correct polarity so that transmit at one end reaches receive at the other. Your installer or network engineer can confirm polarity against your existing patching scheme.
Handle fibre leads with care. Avoid sharp bends, which can damage the fibre and increase signal loss, and do not pull on the cable itself when removing a connector. Keep the connector end faces clean, and fit the dust caps when ports are not in use. Route the lead through the cable managers so it does not strain the connectors. Label both ends so future changes are easier to trace.
Before ordering, check the connector type on each end of your equipment, the fibre grade your network uses, and the length you need, allowing for routing through the rack. A 3 metre lead suits short runs between neighbouring equipment. If you need a different length or a different fibre type, such as singlemode, review the other options in the Molex fibre range before buying.
Molex
LC to LC duplex (DPX), OM3 multimode 50/125µm fibre, 3 m
Article 91.LL.372.00300
Share this on your favourite channel: