





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
MOLEX
LC/LC DPX OM4 fibre patch lead, 50/125µm multimode
Length: 3M
The Molex LC/LC DPX OM4 patch lead is a 3 metre duplex fibre optic assembly built for structured cabling environments. It combines LC connectors at both ends with 50/125µm OM4 multimode fibre, providing a compact and dependable link between network devices and fibre distribution hardware.
This is a factory-made patch lead, sometimes called a patch cord or jumper, used to connect two points in a fibre network. Both ends terminate in LC connectors, which are the small, latching connectors most commonly used on modern switches, transceivers and fibre panels. The DPX label indicates a duplex lead, so the cable contains two optical fibres in one jacketed assembly.
Multimode fibre carries light over a core wide enough for several light paths, which makes it well suited to shorter distances inside buildings, data centres and campus networks. OM4 is a higher performance multimode grade than the older OM1 and OM2 fibres, and it is designed to support higher data rates over the distances typically found within a building. The 50/125µm core and cladding size is the standard for this category.
Handle fibre leads with care. Avoid sharp bends, which can increase signal loss, and do not pull on the cable itself when removing a connector. Keep the connector ends clean and covered until they are plugged in, since dust on the end face is a common cause of link problems. Route leads through cable management so they do not strain the connectors or block airflow in the cabinet.
Before ordering, confirm that the LC connector type and the multimode OM4 grade match the transceivers or ports on your equipment and the patch panels in your installation. Mixing fibre types, such as single mode with multimode, can cause a link to fail or perform poorly.
This lead suits network installers, IT departments, data centre staff and anyone building or maintaining a structured cabling system that uses Molex fibre components. It is a practical choice when a short, ready-terminated multimode link is needed quickly and reliably.
MOLEX
LC/LC DPX OM4 fibre patch lead, 50/125µm multimode
Length: 3M
Share this on your favourite channel: