





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
LC pigtail, OM4 50/125µm multimode fibre, 1 m length
For splicing into fibre panels and enclosures
The Molex LC Pigtail OM4 50/125µm 1M is a short, factory-prepared multimode fibre pigtail with an LC connector on one end. It forms part of the Molex fibre componentry range used to terminate fibre cabling neatly inside panels, cassettes and wall-mounted enclosures. Rather than running a long patch cord, the installer splices the bare fibre end of the pigtail to the incoming cable and connects the LC end to the front of the panel, which gives a clean and consistent connection point.
OM4 is a multimode fibre grade with a 50/125µm core and cladding. It is commonly specified for shorter links inside buildings, data centres and server rooms, where higher data rates over multimode fibre are needed. The one-metre length is chosen for short reach within a rack or enclosure, so there is no excess slack to manage.
A pigtail has one connectorised end and one bare fibre end. Because the fibre is spliced inside the panel, the joint is protected and the fibre is not stressed by repeated plugging and unplugging at the back. The connector that faces the user is the only part that is handled during patching. This makes pigtails a sound choice for permanent cabling, while patch leads are better suited to the day-to-day moves and changes at the front of the rack.
Fibre work calls for care. Keep bend radius within the cable and panel guidelines, keep the connector end-faces clean and covered until they are mated, and label each pigtail clearly so it can be traced back to its port. Splicing should be carried out by a trained installer using appropriate equipment. Confirm the jacket and cable type that suit the particular site before installation, especially where the route runs through ducts, risers or plenum spaces.
This pigtail is suited to fibre termination in data centres, server rooms, campus backbones and office communications cabinets. It is also used in building risers, where fibre is brought into a wall-mounted enclosure and must be presented as a neat LC port. Installers working with Molex fibre panels and cassettes will find it a practical component for completing a fibre link from the incoming cable to the active equipment.
Choose the pigtail to match the fibre grade, core size and connector type used in the rest of the link. OM4 multimode is the grade for this product, so the rest of the channel, including panels, cassettes and patch leads, should be selected to match. Where a different length or fibre grade is needed, check the Molex datasheet range before ordering.
Molex
LC pigtail, OM4 50/125µm multimode fibre, 1 m length
For splicing into fibre panels and enclosures
Share this on your favourite channel: