





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
LSZH OM3 multimode fibre cable, 12 fibres, dielectric construction
Part CFR-00875
The Molex LSZH OM3 I/O Gel Dielectric MLT 12f is a 12-fibre multimode optical cable designed for structured fibre cabling inside buildings. It is listed in the Molex range under the multimode OM3 LSZH sheath cable group, which covers OM3 multimode fibre with a low smoke zero halogen outer sheath. For network designers and installers, this cable provides a fixed fibre backbone that can be terminated into Molex fibre panels, cassettes and enclosures.
Multimode fibre carries light through a relatively wide core, which allows several light paths at once. OM3 is a laser-optimised multimode grade, so it is well suited to short and medium links running at high data rates over Ethernet and storage networks. Because the cable is multimode, it is normally used with optical transceivers and patch leads matched to multimode fibre rather than the narrower singlemode type.
The supplier listing confirms the following: multimode OM3 fibre, twelve fibres (12f), LSZH sheath, and dielectric construction. Further details such as outer diameter, bend radius, maximum pulling tension, operating temperature range and attenuation figures are given in the Molex datasheet for this part and should be checked there before installation.
LSZH sheathing is commonly specified in public buildings, offices, hospitals, transport hubs and schools. When exposed to fire, LSZH materials release far less smoke and avoid the corrosive halogen gases produced by standard PVC jackets. This helps protect occupants and equipment and is often a requirement of building codes and insurance policies. Choosing an LSZH cable from the outset avoids the need to replace sheathing later in a project.
A dielectric cable contains no conductive metal in its structure. This means it cannot pick up induced electrical noise, and it can be installed alongside power cables, lift motors and electrical distribution boards without the bonding and earthing concerns that apply to metallic designs. It also suits environments where electrical isolation between buildings or equipment is needed.
Plan cable routes before installation and leave enough slack at each end for termination and future re-work. Respect the minimum bend radius given in the datasheet, avoid tight cable ties, and use pulling grips rated for fibre cable. Terminate and test each fibre after installation, and label both ends clearly so that the route can be traced later. Keep the cable jacket intact during handling, since damage to the sheath can affect fibre performance.
Because the product sits within a Molex structured cabling system, it works best when the other components, such as panels, adapters, connectors and patch leads, come from the same range. Matching the components helps ensure consistent performance and simplifies warranty and support questions.
Molex
LSZH OM3 multimode fibre cable, 12 fibres, dielectric construction
Part CFR-00875
Share this on your favourite channel: