





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
OM3 multimode fibre cable, LSZH sheath, I/O gel, dielectric construction, MLT 8 fibre
The Molex LSZH OM3 I/O Gel Dielectric MLT 8F is a multimode optical fibre cable designed for structured cabling installations. It belongs to the Molex range of copper and fibre connectivity products, which is used by installers to build reliable data networks in offices, campuses, data rooms and other commercial buildings.
The cable is an OM3 multimode fibre. OM3 is a laser-optimised multimode class, which allows it to carry high-speed data over multimode links. Because it uses multimode fibre, it is well suited to the distances and equipment typically found inside a building, where links run from a main distribution point to network switches, servers and patch panels.
The LSZH sheath is designed to produce little smoke and no halogen gases when exposed to fire. This is important in enclosed or occupied buildings, where smoke and toxic fumes can spread quickly and put people at risk. Many building codes and installation specifications call for low smoke, low halogen cables in ceilings, risers, plenums and cable trays. Selecting an LSZH cable therefore helps designers meet fire-safety requirements while keeping the same fibre performance.
A dielectric cable contains no metal, such as armour or metallic strength members. This makes it suitable for areas near high-voltage equipment, lightning-prone sites, or runs alongside electrical cabling where electrical isolation is needed. The absence of metal also simplifies earthing and bonding considerations, since the cable does not conduct electricity.
The cable should be installed by a qualified fibre installer. Typical steps include routing the cable through containment, leaving sufficient slack at each end, protecting the fibre from tight bends, and terminating or splicing the cores into a splice tray, cassette or fibre panel. Keep the cable clean and capped until termination, since dust and contamination can increase loss at the connector face. Test each link after installation to confirm that it meets the intended loss budget.
Because the cable is a pre-assembled product line, installers often combine it with Molex enclosures, pigtails and patch leads to create complete channels. Matching the connector type and polarity between the cable, the panels and the patch leads will reduce troubleshooting later on.
Choose the Molex LSZH OM3 I/O Gel Dielectric MLT 8F when your project calls for OM3 multimode fibre with an LSZH sheath and a non-metallic construction. Confirm the fibre count, sheath requirement and gel type against your design and the Molex datasheet before ordering. Specifications such as attenuation, bandwidth, bend radius and temperature range should be taken from the official datasheet rather than from this description.
Molex
OM3 multimode fibre cable, LSZH sheath, I/O gel, dielectric construction, MLT 8 fibre
Share this on your favourite channel: