





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6 UTP LS0H patch cord, 568A/B wiring, 5m, green
Structured cabling patch lead for network connections
The Molex PATCH CORD C6 UTP LS0H 568A/B is a five-metre Category 6 patch cord in green. It belongs to the Molex Cat6 patch lead range, which is designed for the short connections that make up the active part of a structured network. Each end is fitted with an RJ45 plug, so the cord can be plugged straight into a patch panel, wall outlet, switch, router or end device.
Patch leads are the flexible links in a cabling system. The permanent horizontal cabling is run through walls, ceilings and trunking, and the patch cords connect that fixed infrastructure to equipment. For this reason patch cords are often replaced, moved or added to as a network changes, while the installed cable stays in place.
The 568A/B designation refers to the pin-to-wire order of the RJ45 connector. The TIA/EIA 568A and 568B schemes are both used in Ethernet installations, and the cord is terminated to that standard so it works with typical structured cabling outlets and patch panels. The LS0H sheath is a low smoke, zero halogen compound. In a fire, it is intended to release less smoke and no halogen gases, which is an advantage in enclosed spaces where people and sensitive equipment are present.
The colour of a patch cord is a practical tool for organisation. In a cabinet with many links, a consistent colour scheme lets a technician see at a glance which connections serve which purpose. The green finish on this cord identifies it within the range, and the same length and specification is available in other colours if a different scheme is needed.
Keep patch cords as short as practical to reduce clutter and cable slack. Route them neatly with cable management, avoid sharp bends and do not pull on the cable when unplugging it; release the latch and remove the plug by the connector body. A five-metre length suits connections between a rack and a desk, or between two racks on opposite sides of a room. For longer runs, the permanent link should be installed with fixed cable rather than extended with several patch cords.
Choose this Molex Cat6 patch cord when you need a five-metre UTP link with the 568A/B wiring standard and a low smoke, zero halogen sheath. If your network uses shielded cabling throughout, or if you need a different length or colour, check the range before ordering so the components match the rest of the installation.
Molex
Cat6 UTP LS0H patch cord, 568A/B wiring, 5m, green
Structured cabling patch lead for network connections
Share this on your favourite channel: