





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6 UTP patch cord, 5m, orange, LS0H sheath, 568A/B wiring
For connecting network outlets, patch panels and active equipment
The Molex PATCH CORD C6 UTP LS0H 568A/B – 5M (Orange) is a ready-made Category 6 patch lead for structured copper networks. It connects the devices and points in a network, such as a wall outlet, a patch panel port, a switch or a computer, using a short, pre-terminated cable that needs no tools or field termination.
Patch leads like this are a basic part of any office, school or commercial network. In a typical installation, horizontal cabling runs from the back of a wall outlet to a patch panel in a cabinet. Patch cords then complete the path, one to the panel and one from the panel to the switch, or from the outlet to the user’s device. Because they are used at both ends of every connection, they see a lot of handling, which is why a clean, well-labelled and correctly sized lead matters.
LS0H is a jacket compound that produces little smoke and no halogen gases when exposed to heat or fire. This makes LS0H cables a common choice in enclosed spaces where people gather or where cables are routed through ceilings, risers and escape routes. If your building or project specification calls for low-smoke cabling, check that LS0H is the required standard before you order.
The 568A and 568B labels describe the order in which the eight conductors are arranged in an RJ45 plug. T568B is the more common pattern in many installations, while T568A is used in some government and legacy setups. The key rule is consistency: both ends of a straight-through patch cord must follow the same pattern, and the wiring used on the patch panel and outlet should match the chosen standard. The 568A/B designation on this product indicates that it is supplied in the form that fits either convention when the ends are terminated correctly.
A five metre lead suits most desk-to-outlet and rack-to-panel runs in a single room or a small cabinet. Measure the path first and allow a little slack, but avoid long loops that can crowd the cabinet and make cable management harder. Orange is a useful identifier: many sites assign colours to particular services, such as data, voice or a specific building zone, so the colour can speed up fault finding and tracing.
Keep bend radius in mind and avoid pulling the cord tight around sharp corners or past its clips. Dress leads with cable ties or Velcro rather than tight bundling, which can deform the cable. Label each end clearly so that the connection is easy to identify later. Keep patch leads separate from power cables where possible to reduce interference, and follow the installation practices required by your network designer.
Using patch leads from the same range as your panels, outlets and cable reduces the risk of mismatched components and makes the whole channel easier to support. Molex Cat6 patch leads are designed to work with Molex Cat6 patch panels, flush-mount outlets and cable, giving installers one consistent system to specify and maintain.
Molex
Cat6 UTP patch cord, 5m, orange, LS0H sheath, 568A/B wiring
For connecting network outlets, patch panels and active equipment
Share this on your favourite channel: