





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6 UTP patch cord, LSOH sheath, 568A/B wiring, 10m, grey
Article PCD-02019-0E
The Molex PATCH CORD C6 UTP LSOH 568A/B – 10M (Grey) is a Category 6 unshielded twisted pair (UTP) patch cord for structured data networks. Supplied in a 10 metre length and grey LSOH jacket, it is intended to link active equipment to patch panels and network outlets within a building.
Patch cords are the short, flexible leads used at the ends of a structured cabling system. Fixed cabling runs through walls and ceilings, while patch cords make the final connection at each end. This cord belongs to the Molex Cat6 range, which is designed to work with Molex DataGate patch panels, jacks and PowerCat 6 cable.
T568A and T568B are the two recognised pin-out standards for eight-position modular connectors. The 568A/B designation means that the termination follows one of these patterns at each end, so the cord is consistent with common installation practice. For a working link, both ends of a patch cord must use the same pattern, and the outlet or panel termination must match the same standard. Installers should check the wiring pattern used across the site before ordering a large quantity.
LSOH jackets release little smoke and no halogen gases when exposed to heat or fire. This makes them a common choice for offices, schools, hospitals and public buildings, where occupant safety and reduced corrosive fumes are priorities. Many building specifications call for LSOH cabling in enclosed or occupied spaces, but the requirements depend on the site, so the project specification should be followed.
A 10 metre cord gives extra reach for equipment placed away from the outlet. Where the distance is short, a shorter cord keeps the cabling tidy and reduces excess slack. Avoid coiling surplus length tightly, as sharp bends can affect performance and damage the jacket. Route patch cords with proper cable management to keep the cabinet and desk areas organised.
Keep patch cords separate from power cables where possible to reduce interference. Label both ends so that connections are easy to trace later. When replacing cords, confirm that the new cord uses the same wiring standard as the rest of the installation, and that the connectors fit the outlets or panels in use.
Molex
Cat6 UTP patch cord, LSOH sheath, 568A/B wiring, 10m, grey
Article PCD-02019-0E
Share this on your favourite channel: