





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6 UTP patch cord, LS0H (low smoke zero halogen) sheath
568A/B wiring, 20 metre length
The Molex PCD-02039 is a 20 metre Cat6 UTP patch cord designed for the everyday connections in a structured network. Patch cords are the short cables that bridge the gap between a patch panel in a rack and the active equipment such as switches, routers, firewalls and servers, as well as the link between a wall outlet and a desk device. This particular cord is made to the Molex Cat6 range and is supplied with an LS0H sheath and 568A/B wiring.
Because the cord is a patch lead rather than bulk cable, its main job is to connect two points quickly and reliably. A correctly terminated Cat6 patch cord is an important part of the link, since the overall performance of a network connection depends on every component in the channel, from the outlet to the switch port.
LS0H stands for low smoke, zero halogen. When a cable jacket with this rating burns, it produces less smoke and no halogen gases, which can be important for visibility and for the health of people escaping a fire and for the protection of electronic equipment. Many building specifications and risk assessments call for low smoke materials in ceilings, risers, cable trays and occupied spaces. LS0H patch cords are therefore a common choice in offices, schools, hospitals, data centres and public buildings.
The cord is wired to 568A/B, the two standard pin arrangements defined for RJ45 connectors. Most network installers use one of these schemes consistently across a building. Confirm that the patch panel, outlet and switch port follow the same scheme as the cord, so that pairs are mapped correctly and the link works as intended.
A 20 metre cord gives generous reach, which helps when a cabinet is located away from the outlet or when cables must be routed along a longer path. For short connections inside a rack, a shorter length will keep cable management tidy. Colour variants are a practical way to distinguish between data, voice, uplink and wireless links, and many installers use a consistent colour code across a site to simplify fault finding.
Avoid bending the cord tighter than the manufacturer recommends, keep it away from strong electrical interference where possible, and secure it with cable ties or management rings rather than pulling tight. Label both ends so that the connection can be traced later. Test each link after installation to confirm that the connection meets the required performance.
For the Molex PCD-02039 Cat6 UTP LS0H patch cord, the combination of Cat6 performance, LS0H sheathing, a 20 metre length and standard 568A/B wiring makes it a practical choice for structured network connections in a wide range of buildings.
Molex
Cat6 UTP patch cord, LS0H (low smoke zero halogen) sheath
568A/B wiring, 20 metre length
Share this on your favourite channel: