





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6A IP67 RJ45 to IP67 RJ45 patch cord, 5 m, black
Molex structured cabling connectivity range

The Molex PCORD C6A IP67 RJ45-IP67 RJ45 5M BLACK is a 5 metre Category 6A patch cord designed for connecting equipment within structured copper network cabling. It belongs to Molex’s CAT 6A connectivity range, which forms part of the Molex copper and fibre structured-cabling portfolio. Patch cords are the short, flexible links that connect one piece of equipment to another, or a device to a fixed cabling point, and this model provides a ready-made solution for that task.
Structured cabling is built around fixed horizontal runs, patch panels, and short patch cords. The patch cord is the part that is handled most often, so it needs reliable connectors and a neat, consistent length. This 5 metre black cord is intended for installations where equipment sits a short distance from a patch panel, wall outlet, or another device, and where a clean, uniform appearance matters.
Category 6A is a copper cabling standard designed for higher bandwidth than Category 6. It is commonly specified for 10 Gigabit Ethernet over twisted pair copper, and for installations that need headroom for future network upgrades. Using Category 6A patch cords throughout a link helps keep the channel consistent with the performance of the cabling it connects to. When selecting a patch cord, it is good practice to match the category of the patch cord to the rest of the installation, so that the system performs as intended.
IP67 is an ingress protection rating. The first digit indicates protection against solid objects, including dust, and the second digit indicates protection against water, in this case protection against temporary immersion. Connectors with this rating are useful where dust, moisture, or occasional wet conditions are present, such as in industrial areas, outdoor enclosures, or sites with poor climate control. The rating describes the connector’s sealing; it does not replace the need to use the cord within its intended environment and to protect joints and cable entries properly.
A 5 metre cord is a practical length for connecting equipment in neighbouring racks, bridging a patch panel to a nearby switch, or running from a wall outlet to a workstation in a small office. Shorter lengths keep cabinets tidy and reduce slack, while longer cords allow for repositioning of equipment. Measure the route before ordering so that the cord is long enough without leaving a large loop of excess cable.
Handle patch cords with care. Avoid sharp bends, do not pull on the cable jacket, and keep the bend radius within the manufacturer’s guidance. Route cords separately from power cables where possible to reduce interference, and use cable management or trunking to keep runs tidy. Label both ends of each cord so that connections are easy to trace during maintenance or future changes.
Because this is a ready-made patch cord, it can be installed quickly without specialist termination tools. It is still important to test the link after installation, particularly in a Category 6A environment, to confirm that the connections are sound and that the link meets the performance you require.
This patch cord suits network installers, IT technicians, and facilities teams who need a dependable Category 6A connection with sealed connectors. It is also useful for system integrators building networks for offices, industrial sites, and technical facilities, where Molex structured-cabling components are already specified.
Molex
Cat6A IP67 RJ45 to IP67 RJ45 patch cord, 5 m, black
Molex structured cabling connectivity range
Share this on your favourite channel: