





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
Cat6A IP67 RJ45 patch cord, 1.5 m, black
Indoor IP67 connectivity range
The Molex PCORD C6A IP67 RJ45 1.5M Black is a short Category 6A patch cord for structured network cabling. Supplied with RJ45 connectors at both ends, it provides a simple, reliable link between the patch panel and the active equipment it serves. The 1.5 metre length and black colour make it a practical choice for neat, well-organised racks and work areas.
A patch cord, also called a patch lead, is a short cable assembly used to make a connection between two points in a network. In a typical installation, one end plugs into a port on a patch panel that is wired back to a wall outlet or another part of the building, and the other end plugs into a switch, router, server or other device. This cord is a Category 6A assembly, which is the Category 6A standard for performance in copper twisted-pair networks.
The product is listed in the Molex range for CAT 6A indoor IP67 connectivity. The IP67 designation in the range name indicates that the connectivity components are built to a high level of ingress protection. Check the Molex product datasheet for the exact rating that applies to this patch cord and the environments it is approved for.
Category 6A cabling is designed to support higher frequencies and greater bandwidth than standard Category 5e or Category 6 cabling. For networks that carry heavy traffic, such as those with many access points, IP cameras, storage devices or high-speed workstations, using Category 6A patch leads helps the whole link perform to its potential. A patch cord is only as good as the rest of the channel, so using matching Category 6A components throughout gives the most consistent results.
This 1.5 metre patch cord suits short connections inside a rack or cabinet. Common applications include:
Plan cable routes before connecting anything. Keep patch cords as short as practical so that slack does not build up in the rack, and route them away from power cables where possible to reduce interference. Label each end clearly so that connections can be traced quickly during maintenance or future changes. Avoid sharp bends near the connectors, and do not pull on the cable itself when unplugging it; hold the connector instead.
The cord is designed to be used as part of the Molex structured cabling system. For the best results, pair it with other Molex Category 6A components such as patch panels, keystone jacks, outlets and wall boxes from the same range. Mixing components from different manufacturers can affect performance, so the datasheet and the rest of the link should be checked before installing a mixed system.
Before ordering, confirm that the length, colour and connector type match your installation. If your project requires a different length or colour, Molex supplies colour variants and other lengths in the same range. Always read the product datasheet for the full technical specification, including the rating and any installation requirements, before fitting the product in a live network.
Molex
Cat6A IP67 RJ45 patch cord, 1.5 m, black
Indoor IP67 connectivity range
Share this on your favourite channel: