





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000

The Molex SC Pigtail OM4 50/125µm 1M is a short, factory-prepared multimode fibre assembly designed for structured fibre cabling. It gives installers a ready-made connection point between a fibre cable and a fibre panel, enclosure or piece of network equipment. The product is listed under Molex’s fibre components, and its article number is 91.30.432.00100.
Fibre pigtails are used wherever a fibre cable has to be terminated neatly inside a distribution point. Instead of fitting a connector onto bare fibre in the field, the installer can splice the free end of the pigtail to the cable and then plug the connector into the panel. This approach is common in data centres, network rooms and building distribution systems where clean, repeatable terminations are important.
Multimode fibre carries light over a larger core than singlemode fibre, which makes it suitable for shorter distances inside buildings and campuses. The 50/125µm designation refers to the diameter of the core and the cladding in micrometres. OM4 is a higher-performance multimode grade that supports higher data rates over longer multimode links than earlier grades such as OM1 and OM2. Because the same grade must be used throughout a link for predictable performance, choosing OM4 pigtails for an OM4 cabling run keeps the installation consistent.
The one-metre length is a practical size for connecting a cable to a nearby panel or enclosure. It avoids excess fibre that would need coiling and storing, and it keeps cable management tidy in cabinets and wall boxes. The SC connector is a push-pull type that is widely used in fibre panels and equipment, which makes it easy to plug in and remove during maintenance or changes.
Before ordering, confirm that the connector type and fibre grade match the panels, adapters and equipment at both ends of the link. Keep the pigtail in its protective packaging until it is ready to be installed, and handle the fibre carefully, avoiding tight bends and sharp edges. Route the fibre within the manufacturer’s recommended bend radius and secure it in a splice tray or enclosure so that it is not strained. Cleaning the connector end before mating it is good practice, as dust on a fibre end can reduce link performance.
This pigtail suits network installers, structured cabling contractors and IT managers who are building or upgrading a fibre network. It is also useful for maintenance teams who need to replace or add a single fibre termination without installing a full new cable run. For projects with specific reach, loss or standards requirements, check the relevant Molex datasheet and your installation design before purchasing.
The Molex SC Pigtail OM4 50/125µm 1M is a compact, ready-to-use multimode fibre assembly for structured fibre networks. Its OM4 grade, SC connector and one-metre length make it a sensible choice for connecting fibre cables to panels and equipment in data rooms, enclosures and distribution points.