





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Molex SC/SC DPX OM4 is a three metre duplex fibre optic patch lead designed for structured cabling installations. It joins two points in a fibre network with an SC connector at each end, and it carries two fibres in a single jacket. The 50/125µm multimode fibre core makes it suitable for short and medium-length links inside buildings, where equipment is located in the same room, cabinet or nearby cabinet.
Patch leads are the flexible connections in a structured cabling system. They link the fixed backbone or horizontal cabling to active equipment such as switches, routers, media converters and servers. Using a factory-terminated lead of known length and grade keeps the installation tidy and makes faults easier to trace than improvised field-made connections.
The DPX label indicates a duplex patch lead, which is the usual arrangement for bidirectional fibre links where one fibre transmits and the other receives. The SC connector is a push-pull, snap-in connector that is widely used in fibre patch panels and network equipment. The 50/125µm figure describes the core and cladding diameter of the multimode fibre. The OM4 rating describes the multimode fibre grade, which is intended for higher-speed short-reach applications when used with compatible transceivers and components.
This patch lead is most often used inside a server room, network cabinet or comms room. A common arrangement is to connect a fibre patch panel at the top of a rack to an access switch or server in the same rack, or to a cable run leading to another rack. It is also used in office, school and healthcare network upgrades where fibre backbones feed local switches.
Installers often keep spare leads of the same type on site. Because the length is fixed at three metres, it is best suited to close-proximity connections where cable routing is planned in advance. For longer runs, a different length or a field-terminated solution may be more appropriate.
Both ends of the link should use matching fibre grades and connector types. Multimode OM4 leads should be connected to multimode ports and transceivers, not singlemode equipment. Keep the connector end faces clean and protected with dust caps when not in use, because contamination is one of the most common causes of poor fibre performance. Avoid sharp bends and do not pull on the jacket when disconnecting. Use the connector body when unplugging.
In summary, the Molex SC/SC DPX OM4 3 m patch lead is a practical, purpose-built component for connecting multimode fibre equipment in structured cabling systems. Its duplex design, SC connectors and OM4 grade make it a straightforward choice for short internal links, provided the connector type and fibre grade are confirmed against the equipment at each end.