





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Molex SC Pigtail OS1/2 9/125µm 2M is a 2 metre single-mode fibre pigtail with an SC connector. It is designed for the termination of single-mode fibre in structured cabling installations, giving a neat connection point between an outside or backbone fibre cable and the active equipment or patch panel on the other side.
A pigtail is a short length of fibre that is factory terminated with a connector on one end. The other end is left bare so that it can be fusion spliced to the fibre in a cable. This method gives a low-loss joint that is protected inside a splice tray and then housed in a fibre enclosure or panel. The SC connector is a push-pull type that is widely used in fibre patch panels and wall boxes.
Single-mode fibre has a very small core, which allows a single light path through the fibre. This reduces signal dispersion and allows the signal to travel much further than multimode fibre. OS1/2 fibre is suitable for long-reach links such as campus backbones, links between buildings and telecommunications routes. Choosing the correct fibre type is important, because single-mode and multimode fibres use different connectors, light sources and transceivers.
The bare end of the pigtail is normally fusion spliced to the cable fibre. Before splicing, the fibre should be stripped, cleaved and prepared using the correct tools. The splice is then protected with a splice sleeve and stored in a splice tray. The 2 metre length gives enough slack to route the fibre from the splice point to the panel without tension on the joint. Keep the bend radius within the manufacturer’s recommendations to avoid signal loss.
Fibre connectors and end faces must be kept clean. Dust or oil on the end face can cause signal loss or back reflection. Use dust caps when the connector is not in use, and clean the ferrule with an approved fibre cleaning tool before mating. Avoid sharp bends and do not pull on the jacket.
This pigtail is sold for professional installation. Check that the fibre type, connector and length match your panel, enclosure and splicing plan before ordering.