





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
1U blank panel for 19-inch cabinets
Article number PAN100.1U
Fills one empty rack unit in a network or server rack
The PAN100.1U is a 1U blank panel for 19-inch network and server cabinets. A blank panel is a flat cover that fits into an empty rack position, filling the gap so the front of the cabinet stays closed. It is one of the most common accessories in a structured cabling or IT installation, because almost every rack has unused space at some point, whether from planned growth or from equipment that has been removed.
Although it is a simple item, a blank panel does useful work. An open rack position lets air move straight through the cabinet from front to back without passing over the equipment that needs cooling. Filling those openings keeps the airflow path more controlled and helps the active equipment in the rack run under more consistent conditions.
The term 1U refers to one rack unit, the standard height unit used in 19-inch racks. A 1U panel occupies a single unit of vertical space. This makes it the most flexible size for filling small gaps, since most switches, patch panels and servers are built in multiples of this height.
Blank panels are used in a number of common situations. Some of the most frequent are listed below.
Fitting a blank panel is quick. Remove the surrounding rails’ retaining hardware only where needed, then secure the panel to the rack rails using cage nuts or the mounting hardware supplied with the cabinet. Make sure the panel sits flush and square with the rails before tightening, so that it does not bulge or sit crooked in the frame. Check that the panel does not foul cables that run past it, and leave room for cable routing where the design of the rack requires it.
When planning a rack, it helps to map out all of the unit positions before fitting equipment. Any position that will stay empty for the time being should be covered with a blank panel. This keeps the cabinet closed, protects the cabling behind the front face, and makes later changes easier to manage.
The PAN100.1U is a closed blank panel. Where ventilation is a priority, a vented panel or brush panel from the same range may be a better choice, since these allow controlled airflow through the front of the rack while still covering the gap. Cable management rings, fibre management trays and cage nuts are also available in the same range for building out a complete rack. Confirm the exact finish and dimensions against the supplier data before ordering, particularly if the panel must match existing equipment or a specific cabinet model.
Overall, the PAN100.1U is a practical, low-cost way to keep a 19-inch rack complete, closed and well organised. It is suited to network rooms, server cupboards, data closets and any other place where racks are used, and it is an easy addition to a rack that is being maintained, expanded or tidied up.
1U blank panel for 19-inch cabinets
Article number PAN100.1U
Fills one empty rack unit in a network or server rack
Share this on your favourite channel: