





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
2U vented panel for 19-inch network cabinets
Article number: PAN200.2U
Standard cabinet accessory for rack space
The PAN200.2U is a 2U vented panel designed for use in 19-inch network and server cabinets. Panels like this are a simple but important part of a well-organised rack. They close off unused mounting space at the front of the cabinet, present a tidy appearance and help control the way air moves through the enclosure.
In a standard 19-inch rack, equipment is measured in rack units, abbreviated as U. One U is 44.45 mm of vertical height. A 2U panel therefore covers two rack units of space. When equipment is removed or when a cabinet is only partly populated, these gaps are left open unless they are filled with blanking or vented panels.
A vented panel has openings across its face, unlike a solid blank. Those openings allow air to pass through the panel rather than blocking it. In a rack with open gaps, air can short-circuit past equipment, and hot exhaust air can be drawn back into the intake side. Keeping gaps covered with panels helps direct the airflow path through the active equipment, and a vented panel does this while still allowing some air movement across the empty space.
Fitting the panel is a quick task. Identify the empty 2U space in the cabinet, then position the panel against the front mounting rails. Secure it using cage nuts and screws in the usual way. Check that the panel sits flush and level, so it does not interfere with doors or with cable routing. If equipment is later installed in that space, the panel can be removed without affecting the rest of the rack.
The PAN200.2U suits system integrators, network installers, data room managers and office IT teams. It is a sensible item to keep in stock for maintenance work, because empty rack space appears regularly as equipment is upgraded, moved or replaced. Buying panels in the correct height for the rack layout helps keep the cabinet orderly and avoids the need for makeshift fillers.
Vented panels work well alongside other standard cabinet accessories. Brush panels can be used where cables pass through the front of the rack. Cable management rings guide patch leads neatly between devices. Fibre management trays help organise fibre runs, and cage nuts provide secure mounting points. Together these items help create a rack that is easy to maintain and easier to work in.
When planning a rack, measure the total height of the cabinet and the height of each device, then fill every remaining space with an appropriate panel. Doing this consistently gives the best results for airflow, cable order and general tidiness over the life of the installation.
2U vented panel for 19-inch network cabinets
Article number: PAN200.2U
Standard cabinet accessory for rack space
Share this on your favourite channel: