





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite MTP/MPO to 4xLC fan-out cable is a fibre optic assembly for high-speed networks. It takes one MTP/MPO multi-fibre connector and breaks it out into four LC connectors, which lets a single high-density trunk port feed several standard LC ports on switches, transceivers or patch panels. It is designed for 40 Gigabit Ethernet links using the 40GBASE-SR4 standard over OM3 multimode fibre.
Modern data centres and server rooms rely on high-density fibre to carry large amounts of traffic in a small physical footprint. MTP/MPO connectors pack many fibres into one plug, which saves space on the patch panel. Most active network equipment, however, still uses individual LC duplex ports. A fan-out cable bridges these two worlds, so the high-density trunk and the standard equipment ports can be connected without rewiring the whole installation.
OM3 is a laser-optimised multimode fibre designed for short and medium distances inside buildings. Because this cable is a short 2 metre assembly, it suits links inside a rack, between adjacent racks or between a patch panel and a nearby switch. The plenum rating means the jacket is suitable for spaces used to move air around a building, such as ceiling voids and raised floors, where local rules call for plenum-rated cabling. Always confirm that the rating meets the requirements of the site before installation.
MTP/MPO connectors are often fitted with push/pull tabs that make it easier to connect and disconnect the plug in dense panels. The tab gives a firm grip without touching the fibre end-face, which helps keep the connection clean. Handling is simpler than with bare multi-fibre ends, and the connector is easier to remove when rearranging a rack.
Before ordering or fitting this cable, confirm that the MTP/MPO end matches the trunk or cassette it will plug into, including the number of fibres and the polarity method used on the link. Keep the connectors covered when not in use and avoid sharp bends, as tight bends can damage fibre. Route the cable so that it is not under strain at the connectors. Label each LC leg clearly so that technicians can trace the links quickly during later moves, adds and changes.
This fan-out suits network engineers, data centre technicians and installers who work with high-density fibre. It is also useful for facilities teams planning upgrades to 40 Gigabit links. Because the cable is supplied terminated, it can be installed without field termination equipment, which keeps installation time short.



