





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
Cat6a shielded STP Ethernet cable, RJ45 to RJ45, 10 ft (3.05 m), grey
PoE compatible, 10G snagless
The Tripp Lite N262-010-GY is a Cat6a Ethernet patch cable for structured cabling and network equipment. Its shielded twisted pair construction, snagless RJ45 connectors and PoE support make it a flexible choice for offices, data rooms and networked buildings.
Category 6a cable is the step up from standard Cat6 for networks that need 10 Gigabit speeds. The shielding around the twisted pairs reduces crosstalk and interference from nearby power cables, lighting and motors. This makes the cable a sensible choice in areas where many cables run side by side, such as cable trays, ceilings and equipment racks.
PoE allows a single cable to carry both data and electrical power. This removes the need for a separate power adaptor at devices such as IP telephones, wireless access points, network cameras and some small network switches. The cable is rated for PoE use, so it can be used in these installations.
The snagless boot on each RJ45 plug covers the locking clip. This makes it easier to pull the cable out of a tightly packed patch panel or switch without catching the latch on the next cable. It also makes the cable easier to route through cable managers.
Choose the N262-010-GY when you need a shielded Cat6a patch lead of about 3 metres between two network devices, particularly where PoE power is required. Grey colouring helps match the cable to most office and rack environments. For longer runs, a fixed cable installed to structured cabling standards is more suitable than a patch lead.
Check the length, connector type and colour against your existing installation before ordering. The cable is supplied as a finished assembly with RJ45 connectors fitted at both ends.
Tripp Lite
Cat6a shielded STP Ethernet cable, RJ45 to RJ45, 10 ft (3.05 m), grey
PoE compatible, 10G snagless
Share this on your favourite channel:



