





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
Duplex Singlemode 9/125 Fiber Patch Cable (LC/SC), 15M (50 ft.)
Singlemode fibre patch lead for network links
The Tripp Lite N366-15M is a ready-made duplex singlemode fibre patch cable, supplied with an LC connector on one end and an SC connector on the other. Its length is 15 metres, which is about 50 feet. The cable is part of the Tripp Lite range of connectivity products from Eaton, which includes fibre active optical cables alongside video, USB and KVM products.
Patch leads are the short, factory-terminated jumpers used to link active equipment to passive infrastructure and to other equipment. This particular lead uses singlemode fibre, which is designed for longer distances and higher bandwidth than multimode fibre. It is therefore a sensible choice when the link between two points is longer or when the network will need room to grow in speed.
Singlemode fibre has a very small core that allows only one light path, or mode, to travel down the cable. Light therefore spreads less and can travel further without signal loss. Multimode fibre has a larger core that carries several light paths, which keeps it cheaper to use over short runs but limits distance. If your switch or transceiver is rated for singlemode, you must use singlemode leads, because the two types do not interchange reliably.
Most fibre network ports send and receive on separate strands. A duplex patch lead bundles these two strands in one jacket and terminates them at both ends, so one connector plug carries both directions of traffic. This keeps cable management simple inside a cabinet or along a cable tray.
LC connectors are small, push-pull plugs that are common on modern transceivers and switches, so they fit a dense panel layout well. SC connectors are larger, square, push-pull plugs that are widely used on older equipment and on many patch panels. A cable with an LC end and an SC end therefore acts as a bridge between two generations of equipment or between a transceiver and a panel with a different connector style.
Fibre cores are fragile and can be damaged by sharp bends, crushing, or dirt on the connector ends. Route the cable with a gentle bend radius, use cable management guides, and keep the dust caps on any unused connector. Clean the connector ends before connecting if your equipment or testing process calls for it. Avoid pulling on the cable jacket with force, and never look into a live fibre end because the light can damage your eyes.
A 15 metre lead suits links inside a room or between equipment in neighbouring racks. Measure the route carefully and allow some slack for connections and future changes, but avoid excessive coiling, which can stress the fibre. If the route is much shorter, a shorter lead may be a better fit, and if it is much longer, consider a custom-length cable or permanent cabling.
The N366-15M is a practical option for anyone who needs a dependable singlemode patch between LC and SC equipment. Confirm your connector types and fibre type before ordering, and make sure the length suits your installation route.
Tripp Lite
Duplex Singlemode 9/125 Fiber Patch Cable (LC/SC), 15M (50 ft.)
Singlemode fibre patch lead for network links
Share this on your favourite channel: