





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Tripp Lite
Duplex Singlemode 9/125 Fiber Patch Cable, SC/SC, 10M (33 ft.)
The Tripp Lite N356-10M is a duplex singlemode fiber patch cable fitted with SC connectors at both ends. It is a 10 metre (33 feet) lead for connecting fiber network equipment inside a building, such as a switch to a patch panel, or one device to another where a fiber link is needed. Tripp Lite is part of the Eaton group, and this product is listed in its fiber connectivity range.
Patch cables like this one are the short leads that make up the last part of a fiber network. They are used in comms rooms, server cabinets and data rooms, where a link needs to be made quickly and cleanly between two pieces of equipment that sit near each other. A ready-made lead of a known length saves the time and skill needed to terminate fiber on site.
Singlemode fiber has a very small core, which allows light to travel along a single path. Because the signal does not spread out as much as it does in multimode fiber, singlemode cable can carry data over longer distances. A patch cable of this kind is a good match for links where the reach between devices may be greater, or where future expansion is likely.
Duplex cable has two strands in the same outer jacket. One strand carries signals in one direction and the other carries signals in the opposite direction. This arrangement is standard for network links that send and receive data at the same time, and it means a single lead can complete a two-way connection.
SC connectors are push-pull connectors with a square housing. They click into place when pushed in and release when pulled out. They are widely used on fiber switches, media converters, transceivers and patch panels. Using SC at both ends means the lead can be connected straight to compatible ports without any adapter.
A 10 metre lead is intended for short runs. Measure the route between the two devices, including any cable management, before ordering. A lead that is too long can create loose loops of cable that are harder to manage, while one that is too short may not reach. Allow for a small amount of slack, but avoid large coils that can crowd a cabinet.
Fiber cable should be treated with care. Avoid sharp bends, which can damage the glass strands, and do not pull on the cable or the connector body when unplugging it. Keep the connector ends clean, and fit dust caps when a connection is not in use. A small amount of dust on a connector end can reduce the quality of the signal, so it is worth keeping the ends clean at all times.
Before buying, check that the equipment at both ends uses SC connectors and singlemode fiber. Connector types and fiber modes must match for the link to work. If your equipment uses a different connector, such as LC, a conversion lead or adapter will be needed. Also confirm that the transceiver or port is rated for singlemode, as multimode equipment will not work with this type of lead.
Ready-made patch leads help keep a network organised. Clear labelling, consistent lengths and properly managed cable paths make faults easier to trace and changes easier to carry out. A duplex singlemode SC lead of a known length fits neatly into that approach and can be used alongside other fiber leads in the same cabinet.
Tripp Lite
Duplex Singlemode 9/125 Fiber Patch Cable, SC/SC, 10M (33 ft.)
Share this on your favourite channel: