





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N390-01M-8LC-AP is a 1 metre yellow singlemode fibre breakout patch cable. It links one MTP/MPO (APC) multi-fibre connector to four LC (UPC) duplex connectors, allowing one high-density port on a switch or panel to be split into several separate LC connections.
High-speed transceivers such as QSFP+ modules use multi-fibre MTP/MPO connectors. Many lower-speed devices, panels and patch fields use individual LC connectors. A breakout cable bridges the two, so one trunk port can serve four separate LC links without needing a separate cable for each.
The MTP/MPO end uses an angled APC polish, and the LC ends use a flat UPC polish. These finishes are not interchangeable. Always confirm that the transceiver, panel and cassette at each end match the polish type before connecting.
The plenum-rated jacket is intended for installation in air-handling spaces, such as above suspended ceilings or under raised floors, where fire-performance requirements apply. Use it where your building or cabling specification calls for plenum-rated cable.
Keep the connectors capped until use and clean the ferrules before mating, as dust is a common cause of signal loss on singlemode links. Avoid tight bends and follow the bend radius guidance for the cable type. Label each LC leg so the four links can be traced back to the trunk port.
Check the connector gender and polish type against your switch, transceiver and patch panel. The 1 metre length suits short, close-proximity connections. For longer or differently configured runs, check the Tripp Lite range for an alternative length.



