





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N816-15M is a 15 metre duplex multimode fiber patch cable with an LC connector at one end and an SC connector at the other. It is designed for short-reach data links within buildings, where a reliable 10 Gigabit connection is needed between active equipment and a fibre patch point.
Fibre patch leads like this one are a common part of structured network cabling. Rather than running a single long cable through a building, installers use patch leads to make the final connection at each end, which keeps the permanent backbone intact and makes moves, adds and changes easier to manage.
OM3 is a laser-optimised multimode fiber. Its 50 micron core is designed to carry 10 Gigabit Ethernet signals over distances that are typical inside a building. The aqua jacket follows the common colour convention for OM3 cables, which helps technicians tell the fibre grade apart quickly during installation and troubleshooting.
LSZH jackets release very little smoke and no halogen gases when they burn. This makes them a sensible choice for cable runs in ceilings, risers, plenums and equipment rooms where people and sensitive electronics need protection in a fire. Always confirm that the jacket type meets the requirements of your building and local regulations.
Before ordering, confirm the connector types on both your equipment and your patch panel. This cable has LC on one end and SC on the other, so it will only fit where those two connector styles are used. Make sure the fibre grade is also compatible with your existing cabling and transceivers. Where a link needs a different length, check the shop for other Tripp Lite lengths in the same range.
Handle fibre patch leads with care. Avoid sharp bends and keep the connector end caps on when the cable is not in use, as dust on a connector end face is a common cause of link problems.



