





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N820-25M-OM4 is a ready-made duplex fiber optic patch cable for high-speed network links. It is 25 metres long, has an LC connector on each end, and uses OM4 multimode fiber with a 50/125 micron core and cladding. The cable is part of the Tripp Lite connectivity range from Eaton, which covers copper and fiber products for offices, server rooms and data centres.
Multimode fiber carries light over short and medium distances, and OM4 is the version of multimode fiber designed for higher data rates than the older OM1, OM2 and OM3 grades. This cable is rated for 100G duplex operation, which means it can carry 100 gigabit traffic over a pair of fibers, one for transmit and one for receive. For many installers, this makes OM4 a sensible choice where a network may need to grow faster over the same routes.
Installing fiber can be fiddly, especially when technicians have to terminate connectors in the field. A pre-terminated patch cable like this avoids that work. The cable arrives ready to use, with both connectors fitted, so it can be plugged straight into a transceiver at one end and a patch panel or switch port at the other.
LSZH stands for low smoke, zero halogen. When this jacket burns, it releases much less smoke and no halogen gases, which are toxic and corrosive. This is why LSZH cables are often required in public buildings, hospitals, transport hubs and enclosed data halls, where clear air and occupant safety are priorities. Check your building or project specification to confirm that LSZH is the sheath type you need.
The aqua jacket is commonly used to mark OM3 and OM4 multimode cable. Using the same colour code across a site makes it easier to keep multimode and singlemode links apart during maintenance, fault finding and expansion work. Mixing the two fiber types on the same link is a common cause of poor performance, so clear colour coding saves time.
This cable is most often used inside a data centre or server room. Common applications include connecting a switch to a fiber patch panel, linking two switches in neighbouring racks, connecting a server network card to a top-of-rack switch, and creating short backbone links within a building. It can also be used in campus networks for building-to-building links over short distances where multimode fiber is suitable.
Before installing, measure the route so that the 25 metre length gives enough slack without leaving excess loops. Keep the bend radius within the manufacturer’s guidance, avoid pinching the cable in cable management, and keep the connector end faces clean and covered until they are plugged in. Label both ends so the cable can be traced later. Make sure the transceivers at each end support the same fiber type and speed.
The N820-25M-OM4 suits network engineers, systems integrators, IT managers and electrical contractors who need a dependable, pre-terminated fiber link. It is a practical choice for anyone building or upgrading a network that requires 100G duplex capacity over multimode fiber.



