





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Hikvision
18 Channel 12VDC 20 Amp CCTV Power Supply
Article number: PS69

The Hikvision 18 Channel 12VDC 20 Amp CCTV Power Supply, article number PS69, is a centralised power source designed for analogue closed-circuit television systems. Instead of powering each camera from its own small adaptor, you can feed a number of cameras from one regulated 12VDC supply. This keeps the wiring tidy, reduces the number of loose adaptors on site, and gives you one point to check when something goes wrong.
The unit is listed in the Hikvision analogue accessories range, alongside the analogue DVRs, turret, dome, bullet and PTZ cameras, monitors and coax cable and connectors that make up a complete analogue system.
Each camera needs a steady 12V supply to operate correctly. When several cameras each have a separate adaptor, the installation quickly becomes cluttered, and it is harder to find a fault. A multi-channel power supply brings all the camera power into one cabinet. Installers can then run a separate cable from the supply to each camera, label the outputs and test the system from a single location.
Before you connect any equipment, add up the current draw of every camera you intend to power and make sure the total stays within the 20 amp rating of the unit. Leave some spare capacity for future expansion. Voltage drop is also important on long cable runs, so keep the cable lengths from the supply to each camera as short as the site allows and use an appropriate cable gauge.
Mount the power supply in a dry, ventilated enclosure, away from direct heat and moisture. Keep mains wiring separated from low-voltage camera cables, and make sure the earth is connected properly. Label each output so that the camera it feeds can be identified quickly during maintenance. Check the supply under load after installation to confirm that the cameras receive the correct voltage.
This unit suits installers, integrators and business owners who are building or extending an analogue CCTV system and want a single, organised power point for their cameras. If your system uses IP cameras instead, check first that this analogue accessory matches your camera type and power requirements.
For the full specification of connector types, fuse protection and mounting dimensions, please consult the manufacturer documentation or ask our team before ordering.
Hikvision
18 Channel 12VDC 20 Amp CCTV Power Supply
Article number: PS69
Share this on your favourite channel: