





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Hikvision
L2 unmanaged hardened PoE switch, 8 Gigabit PoE ports, 2 Gigabit SFP uplinks
110W PoE budget, -30 to 65°C, DIN rail mount

The Hikvision DS-3T0510HP is an unmanaged Layer 2 switch from the Hikvision networking range, designed to power and connect IP cameras and other PoE devices in locations where a standard office switch would not survive. It combines eight Gigabit RJ45 PoE ports with two Gigabit SFP ports for fibre or copper uplinks, all in a hardened housing that is rated for a wide operating temperature range.
Because the switch is unmanaged, there is nothing to configure. Connect your devices, supply power, and the switch begins forwarding traffic and powering connected equipment. This makes it a practical choice for installers who want a simple, dependable network segment at a remote site, on a pole, or inside an industrial control cabinet.
Power over Ethernet (PoE) carries electrical power on the same network cable as data. This removes the need for separate power wiring to cameras, access points and similar devices. The 802.3af, 802.3at and 802.3bt standards describe increasing levels of power that a switch can deliver. The DS-3T0510HP supports these standards, and its high-power ports on ports 1 and 2 can deliver up to 90W to a single device that needs more energy, such as a PTZ camera with heaters and wipers.
The total budget of 110W is shared across all PoE ports. Before installing a large number of powered devices, add up the expected consumption of each device to confirm that the total stays within the budget.
The switch is intended for installations where temperature, electrical disturbance and mounting space are challenges. The -30°C to 65°C operating range allows it to be used in cold outdoor enclosures and hot cabinets. The 6 kV surge protection helps guard against voltage spikes on the network, which are common on long outdoor runs and in areas exposed to lightning or switching surges. DIN rail mounting allows the switch to be fitted neatly in standard industrial cabinets alongside other equipment.
Port isolation prevents devices connected to the switch from communicating directly with each other, which can limit the spread of problems and improve security on shared camera networks. The PoE watchdog feature monitors connected powered devices and can cycle power to a device that has stopped responding, helping to keep remote cameras and access points online without a site visit.
The DS-3T0510HP suits a range of CCTV and access control projects, including outdoor camera networks along driveways, perimeters and car parks, gate and boom barrier installations, and intercom systems. It is also useful in industrial and utility sites, in wireless access point networks, and in any setup where a rail-mounted PoE switch with fibre uplinks is needed. Because it is unmanaged, it is best suited to networks that do not require VLAN configuration or detailed traffic management.
Before ordering, confirm the PoE standard and power draw of each connected device, the distance to each camera or access point, and the type of fibre or copper uplink required. Plan cable routing to keep runs within the stated distances, and check that the mounting location suits the rated temperature range. Where a higher level of control, monitoring or VLAN support is needed, a managed Hikvision switch may be a better fit.
Hikvision
L2 unmanaged hardened PoE switch, 8 Gigabit PoE ports, 2 Gigabit SFP uplinks
110W PoE budget, -30 to 65°C, DIN rail mount
Share this on your favourite channel: