





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Hikvision
1km outdoor 2.4GHz wireless bridge kit, 300Mbps, 2×2 MIMO, 7dBi gain
802.11n, 2 x 100Mbps RJ45 ports, standard PoE in and out

The Hikvision DS-3WF1000-EI-2N is an outdoor customer premises equipment (CPE) wireless bridge kit. It is made to extend a network across open ground, between buildings or to a remote site without laying cable. With a rated maximum distance of 1km on the 2.4GHz band, it suits installers and businesses that need a reliable wireless link between two locations.
A wireless bridge takes the place of a cable run. One unit at each end of the link connects the network on either side, so devices on each site can share data as if they were wired to the same switch. The DS-3WF1000-EI-2N is built for this job and supports both point-to-point and point-to-multipoint connections.
The main specifications listed by the supplier are the following. The wireless band is 2.4GHz and the standard is 802.11n. The antenna is a 2×2 MIMO design with 7dBi gain and a 60 degree horizontal angle. Wireless throughput is rated at up to 300Mbps. Wired connectivity is provided by two 100Mbps RJ45 ports. Power is handled through standard PoE, which can be taken in from a PoE source or passed on to another device.
The supplier has published test results that show how throughput changes with distance and topology. In point-to-point mode the link achieved 70Mbps over 1km and 90Mbps over both 500m and 200m. In point-to-multipoint mode, with one to four connected clients, the throughput was 40Mbps at 1km. These results are useful when planning a link, because they show that performance drops with distance and that a shared multipoint link carries less bandwidth per site than a single point-to-point link.
Because the unit supports standard PoE input and output, the outdoor end of a link can be powered over the same Ethernet cable that carries the data. This removes the need for a separate mains supply at the mounting point. Installers should plan the cable route, the mounting position and the line of sight between the two antennas before installing the kit. The 60 degree horizontal angle of the antenna means the units must be aimed carefully to get the best signal.
The bridge can be configured through its web interface. The product description also lists support for iVMS-4200, HCP and HPP, which allows the device to be managed alongside other Hikvision equipment. Settings such as link configuration and monitoring can be reviewed after installation to confirm that the connection is performing as expected.
Wherever a cable trench, ducting or overhead run would be costly or difficult, a wireless bridge is a practical alternative. The DS-3WF1000-EI-2N gives a wired-style connection between two sites, with the distance, throughput and PoE support needed for most outdoor building-to-building jobs. For the best result, check the line of sight, the distance and the expected number of clients before choosing the topology.
Hikvision
1km outdoor 2.4GHz wireless bridge kit, 300Mbps, 2×2 MIMO, 7dBi gain
802.11n, 2 x 100Mbps RJ45 ports, standard PoE in and out
Share this on your favourite channel: