





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N820-20M-OM5 is a duplex multimode fibre optic patch cable for high-speed network connections. It is supplied as a 20 metre cable with LC connectors on both ends. The fibre is 50/125 micron OM5, the wideband multimode grade, and the cable is intended for 100G duplex applications. The outer jacket is LSZH (low smoke zero halogen) and the cable is lime green.
Fibre optic patch cables are the links that carry data between active equipment such as switches, servers, storage arrays and media converters. Compared with copper, fibre carries signals over longer distances and at higher speeds without electrical interference, which is why it is widely used in backbone links, data centres and multi-building campus networks.
The Tripp Lite part number follows the usual pattern for this range. The middle number shows the length, here 20 metres, and the M suffix confirms that the length is given in metres rather than feet. The OM5 code tells you the fibre grade, which should match the rest of your link so that every component in the path supports the speed you intend to run.
This cable suits several common tasks in a network installation. In a data centre it can connect a top-of-rack switch to a server or to a patch panel in the next cabinet. In a server room it can link a core switch to a distribution switch. It is also useful in buildings where a fibre backbone runs between floors or sections, and where the patch lead needs to be short but not extremely short.
Fibre needs more care than copper. Route the cable with gentle curves and never bend it tighter than its minimum bend radius, because sharp bends increase signal loss. Do not pull the cable by its connectors or by the jacket under tension. Keep dust caps on unused connectors and clean the ferrules before mating them, since a small particle on the end face can disrupt a link. Label both ends so the cable is easy to trace later, and use the lime green colour to separate it from other cabling where that helps your layout.
Because the cable uses LC connectors and multimode fibre, it is intended for equipment with matching LC ports and multimode transceivers. Check the transceiver specification in your switch or server before ordering, and confirm that the speed you plan to use is supported by both the transceiver and the fibre grade. If the link is part of a larger installation, speak to the person responsible for the design so the cable fits the overall plan.
The N820-20M-OM5 gives you a ready-made, correctly terminated patch cable in a length that suits many rack and room layouts. The OM5 fibre supports current 100G duplex needs and offers headroom for future wavelength-based designs. The LSZH jacket meets the requirement for lower smoke in indoor spaces, and the clear colour coding keeps your rack organised.



