





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
The Tripp Lite N844B-10M-12-P is a pre-terminated multimode fibre optic cable for structured cabling and high-speed network links. It combines 12 OM3 multimode fibres with MTP/MPO-PC connectors at each end, providing a plug-in solution for 40, 100 and 400 gigabit Ethernet and similar data links over short to medium distances.
Tripp Lite is a brand of Eaton, and this cable sits in the company’s connectivity range alongside its video cables, adapters and KVM switches. Because the connectors are factory fitted, the cable can be installed without field termination, which helps reduce installation time and the risk of connector damage on site.
MTP/MPO is a multi-fibre connector standard. Instead of terminating each fibre separately as with LC or SC duplex connectors, one MTP/MPO connector holds twelve fibres in a single ferrule. This makes high-density cabling practical: a cassette or panel can carry many channels in a small space, and one cable run replaces several duplex leads.
OM3 is a laser-optimised multimode fibre with a 50 micron core. It is commonly used for short-reach links inside buildings and data centres, where it supports high bit rates over distances that would be too long for older multimode grades. Check your switch or transceiver documentation to confirm the reach and the connector type your equipment needs before ordering.
The LSZH sheath releases little smoke and no halogen gases when burned. This is a common requirement in enclosed spaces such as server rooms, ceiling voids and public buildings, where fire safety rules often call for low-smoke cabling.
Keep the MTP/MPO end faces clean and protected with dust caps until the cable is connected. Avoid tight bends and do not pull the cable by its connectors. Route the cable so it stays within its specified minimum bend radius, and use a fibre inspection scope or cleaning kit to check connectors before mating them.



