





INFRASTRUCTURE TEAM
+27 (0) 11 237 1000
Molex
LC/LC DPX OM3, 50/125µm multimode fibre, 7m
Pre-terminated duplex fibre patch lead for structured cabling
The Molex LC/LC DPX OM3 patch lead is a 7 metre duplex fibre optic cable assembly for connecting network equipment in offices, comms rooms, data centres and campus buildings. It combines two LC connectors on each end with 50/125 micrometre OM3 multimode fibre, giving a neat, pre-made link between a patch panel and an active device such as a switch, server or media converter.
Structured cabling relies on fibre patch leads to make the final connection between the permanent backbone and the equipment that uses it. A pre-terminated lead like this one removes the need to splice or terminate fibre on site, which keeps installation quick and predictable. The 7 metre length is suited to many rack-to-rack and cabinet-to-panel runs in a medium-sized room.
Multimode fibre has a relatively large core, which allows light to travel along several paths at once. This makes it well suited to short and medium distances inside buildings, where cost and ease of installation matter more than the very long reach of single-mode fibre. The 50 micrometre core and 125 micrometre cladding define this class of fibre.
OM3 is a laser-optimised multimode grade. It is widely specified for 10 gigabit Ethernet and other high-speed data links over premises distances. Choosing OM3 fibre for patch leads helps keep the whole channel consistent, because the patch cords match the grade of the backbone and the equipment they connect to.
LC connectors are small form factor fibre connectors with a push-pull latching action. The duplex design joins two fibres in one connector housing, so one lead carries transmit and receive paths together. This simplifies cable management in tight patch panels and switch ports, where a large number of connections must be made in limited space.
Duplex patch leads should be connected with the correct polarity so that transmit at one end reaches receive at the other. Labelling both ends at installation makes later moves, adds and changes easier and reduces troubleshooting time.
Fibre is more sensitive to handling than copper. Keep the connector end faces clean and fit dust caps whenever a lead is unplugged. Avoid sharp bends or tight loops, which can increase signal loss and stress the fibre. Route the lead through cable managers so that it is supported and not pulled taut at the connector. Store spare leads in a dry, clean place and coil them loosely with a generous radius.
Before installation, check that the lead’s connector type and fibre grade match the ports at both ends. Confirm the polarity arrangement with the network design and label the lead clearly. Following these simple steps helps protect the link and keeps the network reliable over time.
Use Molex article number 91.LL.372.00700 when ordering this assembly to ensure you receive the correct LC/LC DPX OM3 7 metre patch lead. If a different length or fibre grade is required, check the relevant Molex datasheet for the matching part.
Molex
LC/LC DPX OM3, 50/125µm multimode fibre, 7m
Pre-terminated duplex fibre patch lead for structured cabling
Share this on your favourite channel: